How to extract cloud points perimeter?

[DA523]

Is there any tool or plugin in CC to auto extract cloud points perimeter?

Mesh.zip

(1.26 MiB) Downloaded 1123 times

perimeter.png (115.39 KiB) Viewed 15823 times

[daniel]

Have you tried the 'Tools > Fit > Facet' tool?

Part of the result should be the contour.

[daniel]

Oh, and of course, you can do nice contour extraction with the 'Cross section' tool (https://www.cloudcompare.org/doc/wiki/i ... le_contour)

[DA523]

I tried every thing but no luck because perimeter points has different z level .
Fortunately , my cloud points are always dense (generated by mesh sample points) this why I think it is not default to find perimeter point with some algorithm

[WargodHernandez]

It should not matter if they are not on the same Z level, I think the confusion is terminology, in the cross section tool under extract contours, the thing you are asking for is called "Extract envelope" rather than extract contours.

extractEnvelope.JPG (92.59 KiB) Viewed 15733 times

[WargodHernandez]

Also if you want the points near the envelope, you can use the Cloud to Primitive distance tool to evaluate each point to the polyline that represents the envelope

extactenvelopeDistance.JPG (46.36 KiB) Viewed 15732 times

You can then filter the cloud based on that distance.

[DA523]

This helps a little but Z values of polyline does not match Z of perimeter of mesh?
XY are OK

The goal of extracting of mesh perimeter is to build with minimum manual intervention more realistic cover for mesh instead of close hole function in Blender and FreeCAD etc
This cover is to be used as upper cloud points for volume (2.5Dvolume) calculation in CC and GIS etc

cont.png (97.71 KiB) Viewed 15729 times

[WargodHernandez]

you could extract z coord to a scalar field for storage, then set all Z values to 0, then extract envelope, then measure distance to primitive, then restore the Z coord from the scalar saved earlier

[DA523]

you could extract z coord to a scalar field for storage, then set all Z values to 0, then extract envelope, then measure distance to primitive, then restore the Z coord from the scalar saved earlier

I will try this approach.

However, I found that polyline contour sometimes is not accurate in xy plane especially if there is big variation in mesh Z
see in image below
.

polyline.png (136.93 KiB) Viewed 15661 times

.
But playing with grid step & min. vertex count makes result polyline accurate in xy plane
.

22.png (97.4 KiB) Viewed 15652 times

2.png (53.22 KiB) Viewed 15652 times

.

a.zip

(447.55 KiB) Downloaded 903 times

grid.zip

(1009.13 KiB) Downloaded 867 times

[WargodHernandez]

I had good success following what I told you, zeroing out the Z value getting the contours then restoring the Z values. only extra step I didn't mention was to interpolate the original clouds SF values to the vertices of the extracted contours and restore the Z SF to the vertices as well to get the contours to follow up to the original locations.

both_A_And_Grid.JPG (123.76 KiB) Viewed 15640 times