Is there a way to set the colours of classification codes?
Not that I am _not_ talking about the RGB colour of the points - rather, I'm talking about the display colour of the points within CloudCompare.
I would like to (a) load in a set of default classification colours for the defined ASPRS classification codes, and (b) set new classification colours for project-specific classification codes.
For example, I would like the following colours to be used. These are the standard classification colours that I've seen elsewhere in point cloud viewing software:
Ground = Brown
LowVeg = Light Green
MedVeg = Med Green
HighVeg = Dark Green
Water = Blue
etc.
Thanks!
Set classification display colour?
Re: Set classification display colour?
Well, you can define your own 'custom' color scales (see https://www.cloudcompare.org/doc/wiki/i ... es_Manager).
You'll have to use the 'absolute' mode, where you can associated a specific value to a specific color. And to have a range of values that correspond to the same color, you'll have to cheat a little bit, by defining steps at 1.0 and 1.999 with the same color, and then 2.0 and 2.999 with another color, etc.
You'll have to use the 'absolute' mode, where you can associated a specific value to a specific color. And to have a range of values that correspond to the same color, you'll have to cheat a little bit, by defining steps at 1.0 and 1.999 with the same color, and then 2.0 and 2.999 with another color, etc.
Daniel, CloudCompare admin