complie the cloudcompare in the windows 7

[snfge]

HI , I set the "OPTION_USE_EXF_LIB" is "D:/CloudCompare/trunk-20150519/dxflib-3.3.4-src/src", does here hase some problem?

[daniel]

Well if the project compiles properly afterwards, then it should be ok...

[snfge]

Hi , In the "dxflib", it only hase *.cpp and *.h, it oK, it need hase the lib file?

[daniel]

Nope, CMake will create a dedicated 'project' for this library. You should see it in Visual Studio (if you compile with VIsual?).

[snfge]

Hi
When I complie the cloudcompare in vs2010, it can create the "DXF_LIBd.lib", but I can not read the dxf file. why? could you give me your email address, I can send some picture to you. thank you.

[daniel]

Yes: cloudcompare [at] danielgm.net (replace the [at] by @)