Page 2 of 2
Re: complie the cloudcompare in the windows 7
Posted: Sun May 24, 2015 12:12 am
by snfge
HI , I set the "OPTION_USE_EXF_LIB" is "D:/CloudCompare/trunk-20150519/dxflib-3.3.4-src/src", does here hase some problem?
Re: complie the cloudcompare in the windows 7
Posted: Mon May 25, 2015 7:14 am
by daniel
Well if the project compiles properly afterwards, then it should be ok...
Re: complie the cloudcompare in the windows 7
Posted: Mon May 25, 2015 11:56 pm
by snfge
Hi , In the "dxflib", it only hase *.cpp and *.h, it oK, it need hase the lib file?
Re: complie the cloudcompare in the windows 7
Posted: Tue May 26, 2015 12:17 pm
by daniel
Nope, CMake will create a dedicated 'project' for this library. You should see it in Visual Studio (if you compile with VIsual?).
Re: complie the cloudcompare in the windows 7
Posted: Wed May 27, 2015 4:19 am
by snfge
Hi
When I complie the cloudcompare in vs2010, it can create the "DXF_LIBd.lib", but I can not read the dxf file. why? could you give me your email address, I can send some picture to you. thank you.
Re: complie the cloudcompare in the windows 7
Posted: Wed May 27, 2015 9:37 am
by daniel
Yes: cloudcompare [at] danielgm.net (replace the [at] by @)