Page 1 of 1
Fly through mode for the camera
Posted: Mon May 21, 2012 7:52 am
by daniel
From Scott M.:
<< I was wondering if you are planning on a fly through mode for the
camera. If I have a 3D scan of a room its somewhat hard to get inside
to look at the scan data. >>
Re: Fly through mode for the camera
Posted: Wed Jul 18, 2012 3:44 pm
by jfhullo
Maybe its a good idea to add something like in sketchup:
- Pick a point, and then place the camera like 1.80m up to this point (z axis), and auto toogle to viewer baser perspective.
Eventually, we could add shortcuts for allow a (really simple) navigation:
-UP : forward (in regard to the current view direction done by viewer based perspective) with constant z
-DOWN : backward constant z
Maybe also some Left Right, but not really needed if using center based perspective...
The only problem is that you cannot use EDL in this case, since EDL doen'st work when camera is close are inside a bounding box...
Only ideas,
JFH
Re: Fly through mode for the camera
Posted: Sat Jan 21, 2023 6:57 pm
by el_tasak
Maybe WSAD key for moving forward, bacward, strafe left and right? Like in other software.
Re: Fly through mode for the camera
Posted: Thu Jan 26, 2023 11:06 pm
by PablerasBCN
WASD + MOUSE would be a blast.