how to flatten an area ? (for later 2.5D comparsion)
Posted: Tue Jan 02, 2018 1:06 pm
I wish to compare an sloping area to the same volume it would had if it were empty.
started by selecting an area, then cloning it.
How can I flatten the clone to it's outline ? , keeping the outline elevation, and interpolating everything inside should give sort of realistic "ground level" at an sloping angle ... the the two could be compared..
started by selecting an area, then cloning it.
How can I flatten the clone to it's outline ? , keeping the outline elevation, and interpolating everything inside should give sort of realistic "ground level" at an sloping angle ... the the two could be compared..