CloudCompare forum

Hi!
I stasted to use CloudCompare recently. I must model a skulpture. I made the unregular things with mesh.
I have some problems with basis. It is a regular cube.
Is there posibility in CC to fill it.
I tried Primitive Factory, but I don't know how to move it to the right place.

Not sure CC is the right tool to do that... But anyway, to move a cube or anything else, see: https://www.cloudcompare.org/doc/wiki/i ... ation_Tool

Thank you for answer.
If it not works I think I will use Blender to this part